Author |
Message |
andyrm
|
Post subject: Looking to get a new ST Posted: Wed Dec 07, 2011 11:24 am |
|
Joined: Wed Dec 01, 2010 4:45 pm Posts: 165
|
OK, in looking at my stats below, is there a particular pin length and/or top weight I should for when ordering a new 15# Sigma Tour. I will be using it to replace my 16# SR2 as I am going all 15# now. It will be my benchmark ball and most use will be on ths. Just want to make sure I order the right ball. I will be back for drilling parameters shortly. Thanks in advance.
_________________ SR2: HG300 HS692(Ret) Recon RX1 Silver 245 645 Primal TV4 287 736 Sigma Tour 298 725 Primal Scream 265 694 55x40@4.5 PAP 4 1/4">5/8 up Rev=300 Release speed 16.1 MPH Axis Rotation 90* Axis Tilt 10*
|
|
Top |
|
 |
JustinWi
|
Post subject: Re: Looking to get a new ST Posted: Wed Dec 07, 2011 4:39 pm |
|
Joined: Thu Aug 27, 2009 10:43 pm Posts: 1707 Location: Rochester NY
|
3" pin and 3oz top weight are the most versatile out of box specs.
|
|
Top |
|
 |
andyrm
|
Post subject: Re: Looking to get a new ST Posted: Wed Dec 07, 2011 5:02 pm |
|
Joined: Wed Dec 01, 2010 4:45 pm Posts: 165
|
Thank you
_________________ SR2: HG300 HS692(Ret) Recon RX1 Silver 245 645 Primal TV4 287 736 Sigma Tour 298 725 Primal Scream 265 694 55x40@4.5 PAP 4 1/4">5/8 up Rev=300 Release speed 16.1 MPH Axis Rotation 90* Axis Tilt 10*
|
|
Top |
|
 |
andyrm
|
Post subject: Re: Looking to get a new ST or Raptor Posted: Wed Dec 07, 2011 8:51 pm |
|
Joined: Wed Dec 01, 2010 4:45 pm Posts: 165
|
What about a Raptor? I may be picking one of these up for high oil conditions. Is there a particular pin length and/or top weight I should request?
_________________ SR2: HG300 HS692(Ret) Recon RX1 Silver 245 645 Primal TV4 287 736 Sigma Tour 298 725 Primal Scream 265 694 55x40@4.5 PAP 4 1/4">5/8 up Rev=300 Release speed 16.1 MPH Axis Rotation 90* Axis Tilt 10*
|
|
Top |
|
 |