motivbowling.com
http://www.motivbowling.com/forum/

question for Justin, Primal Impulse
http://www.motivbowling.com/forum/viewtopic.php?f=8&t=14824
Page 1 of 1

Author:  TOP5 [ Sun Dec 18, 2011 12:02 am ]
Post subject:  question for Justin, Primal Impulse

Justin, you and me have a simmilar bowling style. Are stats are nearly the same except I am more speed/rev balanced. I would like to know your favorite Primal Impulse layout and how you would adjust it for speed = revs

Author:  StickZ [ Tue Dec 20, 2011 1:27 am ]
Post subject:  Re: question for Justin, Primal Impulse

justin isnt speed/rev balanced? wow bold statement

Author:  back2front [ Tue Dec 20, 2011 9:31 am ]
Post subject:  Re: question for Justin, Primal Impulse

StickZ wrote:
justin isnt speed/rev balanced? wow bold statement


Yikes :o

Author:  JustinWi [ Tue Dec 20, 2011 7:48 pm ]
Post subject:  Re: question for Justin, Primal Impulse

My 20MPH/495RPM is still a bit rev dominant.

What is your tilt?

Author:  TOP5 [ Tue Dec 20, 2011 8:51 pm ]
Post subject:  Re: question for Justin, Primal Impulse

tilt 10* rotation 60* pap 5 over 1/4 up

Author:  JustinWi [ Tue Dec 20, 2011 9:43 pm ]
Post subject:  Re: question for Justin, Primal Impulse

My favorite is:

35x45@5.125". P2 Hole, Box Surface.

Just make the pin to PAP distance 5".

Author:  TOP5 [ Wed Dec 21, 2011 1:20 am ]
Post subject:  Re: question for Justin, Primal Impulse

Thanks Justin. I am not surprised you picked that one, in fact I was hoping you would. I liked the reaction I saw in the video. question about the 35* first angle. Did you go with that number to intentionally add side weight for an extra hole? I know as far as the total diff and int. diff is concerned the P2 hole is neutral. does the P2 hole affect the PSA at all? would there be a difference if I went with a larger angle and no hole?

Author:  TOP5 [ Sun Dec 25, 2011 7:26 pm ]
Post subject:  Re: question for Justin, Primal Impulse

*bump*

Author:  JustinWi [ Mon Dec 26, 2011 5:51 pm ]
Post subject:  Re: question for Justin, Primal Impulse

I used that short of a drilling angle because I was planning on using the hole.

I have to spin it to confirm where the PSA ended up. The hole placement is closest to the intermediate axis and shouldn't have done too much to move or impact the others.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/