motivbowling.com
http://www.motivbowling.com/forum/

layout suggestions for GT1 Please
http://www.motivbowling.com/forum/viewtopic.php?f=8&t=1547
Page 1 of 1

Author:  bsbowlerama [ Sun Sep 19, 2010 12:30 am ]
Post subject:  Re: layout suggestions for GT1 Please

Sounds like you want double thumb drill

Author:  Bob Michalojko [ Sun Sep 19, 2010 7:26 am ]
Post subject:  Re: layout suggestions for GT1 Please

There was an article by Mo Pinel in a recent Bowling This Month magazine talking about a drilling layout that was used at the Plastic Ball tourney. Supposedly good for low diff balls which the GT1 is. Here is the web link:

http://www.morichbowling.com/resources/ ... rticle.pdf

If you do drill a GT1 this way, please post the results. Good Luck!

Author:  JustinWi [ Mon Sep 20, 2010 11:09 pm ]
Post subject:  Re: layout suggestions for GT1 Please

Gut says to use a 40x20@4", but I punched one label leverage and it has the strongest backend of the 6 I have drilled. A double thumb will max the dynamics, but you will want some polish to aid it with length. Without knowing your specs, it is tough to pin down a specific recommendation.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/