| Author |
Message |
|
Randy T
|
Post subject: SX-1 layout  Posted: Mon Sep 20, 2010 4:28 pm |
|
Joined: Wed Aug 18, 2010 7:45 pm
Posts: 98
Location: Boulder,Co
|
|
I picked up an SX-1 to go between my purple QZ-1 and my Reacon.
curious on a drilling for it.
High rev med to slower speed.
Want it go get some length
|
|
| Top |
|
 |
|
JustinWi
|
Post subject: Re: SX-1 layout Posted: Mon Sep 20, 2010 10:59 pm |
|
Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1690
Location: Rochester NY
|
|
The biggest thing to worry about will be the surface. 4k and polish if you want it go go long.
Take a second look at my recon vid, you can clearly see the difference between the SX1 and RX1 with identical drill patterns.
What layouts do you have on the other two balls?
|
|
| Top |
|
|
|
Randy T
|
Post subject: Re: SX-1 layout Posted: Tue Sep 21, 2010 5:35 pm |
|
Joined: Wed Aug 18, 2010 7:45 pm
Posts: 98
Location: Boulder,Co
|
|
I went with High track length drilling on purple per drill sheet
and on the Reacon pin above ring small weight hole
|
|
| Top |
|
|
|
JustinWi
|
Post subject: Re: SX-1 layout Posted: Tue Sep 21, 2010 7:48 pm |
|
Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1690
Location: Rochester NY
|
|
Are you looking for a sharper or smoother breakpoint?
|
|
| Top |
|
|
|
Randy T
|
Post subject: Re: SX-1 layout Posted: Tue Sep 21, 2010 8:29 pm |
|
Joined: Wed Aug 18, 2010 7:45 pm
Posts: 98
Location: Boulder,Co
|
|
I like the ball smooth.
The purple drilled on your suggestions as well as the Reacon are that way nice and smooth.
with the higher revs the ball being flippy for me, makes it difficult to be consistent
|
|
| Top |
|
|
|
JustinWi
|
Post subject: Re: SX-1 layout Posted: Tue Sep 21, 2010 11:22 pm |
|
Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1690
Location: Rochester NY
|
|
Before drilling, hit it with 4k Abralon, then Polish.
Do a 65x70@5". You most likely will not need one, but if you need it a bit weaker place a P1 hole. Keep an eye on the statics before you place the hole.
This layout is a bit weaker than the second SX1 featured in the Recon vid. The surface is at 1k Abralon in the video, with 4k and polish you should see a weaker reaction. Sliding the SX1 between the RX1 and QZ1 can be tough sometimes, it likes to hook.
|
|
| Top |
|
|
