MOTIV

Username: Log me on automatically each visit
Password:
It is currently Tue Sep 02, 2014 2:54 pm


Post a new topicPost a reply Page 1 of 1   [ 8 posts ]
Author Message
 Post subject: Justin, layout for my NEW Thrash!
PostPosted: Tue Jan 17, 2012 1:09 am 

Joined: Wed Oct 20, 2010 5:40 pm
Posts: 123
Location: Antigo, WI
Bowler Information:
PAP: 5 3/8" over 5/8" up
Ball Speed: 15-15.5 mph
Rev Rate: 325
Tilt: 5-6*
Rotation: 40-45*


Ball Information:
Make and Model of ball: Thrash
Weight: 15lbs. 1oz.
Desired reaction shape: Get through the heads with stronger motion on backend when needed.


Environment information:
What conditions you intend to use the ball on: 41ft. THS
Lane surface, if known: Newer Brunswick synthetics and older AMF synthetics. The place with the Brunswick lanes tends to have a bit more friction up front, I have had good success with my TZ3 and a mildly drilled Storm Tropical Breeze there. Need a compliment to those.

Conditioner, if known: Kegal

_________________
Chris Orgeman
MOTIV Lineup
Recon RX1S - 60x50@4"
TZ3 - 50x35@4.75"
Thrash - 50x70@5.25" (Polish)
Venom Toxin - Coming soon!


Top
 Profile  
 
 Post subject: Re: Justin, layout for my NEW Thrash!
PostPosted: Tue Jan 17, 2012 1:23 am 

Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1698
Location: Rochester NY
60x55@5.25", no hole to start. Might need some PG Polish to encourage a bit of angularity, there is a strong cover on the Thrash.


Top
 Profile  
 
 Post subject: Re: Justin, layout for my NEW Thrash!
PostPosted: Tue Jan 17, 2012 1:01 pm 

Joined: Wed Oct 20, 2010 5:40 pm
Posts: 123
Location: Antigo, WI
Thanks again Justin. I'll try it at the OOB finish first, then see if it needs a some PG polish. :)

JustinWi wrote:
60x55@5.25", no hole to start. Might need some PG Polish to encourage a bit of angularity, there is a strong cover on the Thrash.

_________________
Chris Orgeman
MOTIV Lineup
Recon RX1S - 60x50@4"
TZ3 - 50x35@4.75"
Thrash - 50x70@5.25" (Polish)
Venom Toxin - Coming soon!


Top
 Profile  
 
 Post subject: Re: Justin, layout for my NEW Thrash!
PostPosted: Wed Jan 25, 2012 8:43 pm 

Joined: Wed Oct 20, 2010 5:40 pm
Posts: 123
Location: Antigo, WI
Justin,
The layout you gave me would have put the pin right between my finger bridge, so we tweaked your layout a bit and ended up with:
50x70@5.25"

The pin ended up just below my fingers, which always worries me because of my higher track.

What do you think? I think it should be fine, it's a layout I don't have on any of my other stuff.

_________________
Chris Orgeman
MOTIV Lineup
Recon RX1S - 60x50@4"
TZ3 - 50x35@4.75"
Thrash - 50x70@5.25" (Polish)
Venom Toxin - Coming soon!


Top
 Profile  
 
 Post subject: Re: Justin, layout for my NEW Thrash!
PostPosted: Wed Jan 25, 2012 10:54 pm 

Joined: Mon Oct 11, 2010 3:58 pm
Posts: 405
Location: Countdown County FLA
be careful you dont track over the holes, im a high track bowler and going pin under is a no no

_________________
Jason Drouin
"StickZ"
Self-Proclaimed
House Hack Motiv Staff =)


Top
 Profile  
 
 Post subject: Re: Justin, layout for my NEW Thrash!
PostPosted: Wed Jan 25, 2012 11:19 pm 

Joined: Wed Sep 22, 2010 12:14 am
Posts: 804
Location: Iowa Falls, IA
Remember, as a check, you can verify ahead of time where your bow-tie will be: draw a line from your PAP thru the pin. Where that line intersects your track will be the center of the bow-tie. If you track close to the fingers, and the bow-tie is not 'above' the finger holes (meaning farther away from your grip center line than the finger holes), the last couple of flare tracks will most likely roll over your finger hole (or holes). Easy to check before putting holes in a ball.

_________________
Lane 13 Pro Shop, Iowa Falls, IA ............. Venom Shock * Recon
Proprietor, Pla-Mor Bowl ........................ GT1 * Covert Revolt.
Vise Grips Amateur Staff ......................... Sigma Sting * Tribal


Top
 Profile  
 
 Post subject: Re: Justin, layout for my NEW Thrash!
PostPosted: Thu Jan 26, 2012 12:24 pm 

Joined: Wed Oct 20, 2010 5:40 pm
Posts: 123
Location: Antigo, WI
Thanks for the response, but I watching Justin's video and the last Thrash that he throws is drilled 75x65@5". You can see it at the 1:46 mark of the video.
http://www.youtube.com/watch?v=otc4HT6z5aQ

Mine layout looks very similar to his except my cg is kicked out a bit more and there's a weight hole drilled down the VAL at an angle to move my track away from the center. I'll attach a pic later.

His PAP: 5 over 1/2 up
Mine: 5 3/8 over 5/8 up
His tilt: 8*
Mine: 6*

So not that far off. If you draw a line from his PAP thru the pin his "bow-tie" will obviously be below his fingers.
Maybe he doesn't track that close to his fingers but I like to see Justin he has to say about this. I'm going to be able to throw the ball tomorrow, so I'll let you know what happens.

plamormick wrote:
Remember, as a check, you can verify ahead of time where your bow-tie will be: draw a line from your PAP thru the pin. Where that line intersects your track will be the center of the bow-tie. If you track close to the fingers, and the bow-tie is not 'above' the finger holes (meaning farther away from your grip center line than the finger holes), the last couple of flare tracks will most likely roll over your finger hole (or holes). Easy to check before putting holes in a ball.

_________________
Chris Orgeman
MOTIV Lineup
Recon RX1S - 60x50@4"
TZ3 - 50x35@4.75"
Thrash - 50x70@5.25" (Polish)
Venom Toxin - Coming soon!


Top
 Profile  
 
 Post subject: Re: Justin, layout for my NEW Thrash!
PostPosted: Fri Jan 27, 2012 3:29 pm 

Joined: Wed Oct 20, 2010 5:40 pm
Posts: 123
Location: Antigo, WI
Got to throw the ball today, no problem with rolling over my track at all. Didn't even come close. Ball rolls really well with great continuation as advertised!

_________________
Chris Orgeman
MOTIV Lineup
Recon RX1S - 60x50@4"
TZ3 - 50x35@4.75"
Thrash - 50x70@5.25" (Polish)
Venom Toxin - Coming soon!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 8 posts ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

MOTIV