motivbowling.com
http://www.motivbowling.com/forum/

Need recommendation for layout on the Raptor Attack
http://www.motivbowling.com/forum/viewtopic.php?f=8&t=19038
Page 1 of 1

Author:  labchem [ Sat Mar 03, 2012 10:34 pm ]
Post subject:  Need recommendation for layout on the Raptor Attack

This question is for Justin. Should I drill the Raptor Attack using the same layout and pin as the Raptor P7 since the cover stock is different? Below are my specs. All of the equipment listed in my sig is working fine 8-) . My favorites listed in order are the Sigma (3.5 pin), Raptor P7 (3.8), and Primal Impulse (3.3 pin). I'm just trying to make sure I dial-in the new Attack like all of us are trying to accomplish.

PAP: 4 5/8" 1/4" up
Rev Rate: 250
Speed: 16 MPH
Axis Tilt: 13
Axis Rotation: 60
Vise "It" Thumb Insert

Author:  JustinWi [ Sun Mar 04, 2012 5:29 pm ]
Post subject:  Re: Need recommendation for layout on the Raptor Attack

55x35@4.75" should compliment the original Raptor and SigT well, should fit right between. Add a hole to tune if need be.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/