motivbowling.com
http://www.motivbowling.com/forum/

Redrilling my Tx1, I finally have my info.
http://www.motivbowling.com/forum/viewtopic.php?f=8&t=23888
Page 1 of 1

Author:  Jellert1 [ Sun May 13, 2012 10:56 pm ]
Post subject:  Redrilling my Tx1, I finally have my info.

Right handed
PAP = 6.25 over and 2.75 up
Speed = 17.6 @ Release
Rev Rate = 420
Axis Tilt = 2 degrees

My Tx1 was never my go to ball, but I really didn't do more than just stab 3 holes in it when I got it. On Friday I had a silver level coach help me get the above info. I would like to fill and redrill my Tx1 (3.5" pin) using the dual angle method. It will be my first time using this method. I'll be bowling on Brunswick lanes with a 42' THS which I think is actually the Kegel Stone Street pattern. I prefer ball motions that have a fairly late, not too agressive snap. Balls that make extreme snappy (skid / flip) motions have never worked well for me. Every ball I have drilled is a full roller lay out. I'm open to all sugestions, this should be a very educational experiment for me. Thank you in advance.

Author:  JustinWi [ Mon May 14, 2012 8:00 pm ]
Post subject:  Re: Redrilling my Tx1, I finally have my info.

60x25@5.25" no hole to start, you'll like the strong arc backend.

Author:  Jellert1 [ Mon May 14, 2012 10:20 pm ]
Post subject:  Re: Redrilling my Tx1, I finally have my info.

Thanks Justin, I'll drill it up and post the results.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/