| Author |
Message |
|
evildawg35
|
Post subject: silver recon and sigma tour layout  Posted: Mon May 14, 2012 12:23 am |
|
Joined: Sat Mar 31, 2012 5:57 pm
Posts: 3
|
|
I'm looking for any suggestions on a layout for my new silver recon and sigma tour. I recently just got my stats, and they are as follows,
Left handed
490 rpm
Speed 19.5 mph
Pap is 3 5/8" over and up one inch
8 degree release angle
My driller is looking to use the dual angle method, but it will their first time doing it. Need something to get down the lane a little, since I flare the ball A LOT. As of right now I am flaring a weather co. Urethane ball 5-7". First suggestion I had was 85 5 50. I am seeing if this is a good layout for my sigma and where I should go with my recon. Thanks in advance
E VanHevel
Sigma tour
Silver recon rx1
Primal tv4 (sarge Easter)
|
|
| Top |
|
 |
|
Jellert1
|
Post subject: Re: silver recon and sigma tour layout Posted: Wed May 16, 2012 11:35 pm |
|
Joined: Tue Jan 04, 2011 3:09 pm
Posts: 296
Location: Metro Detroit
|
|
Here is what I came up with, it will be negative. Based on the way you are throwing that negative "urethane weather co" I think this will be ok for the majority of the patterns we see. Might not be the greatest on the 47 footer we'll get tomorrow. Stop by before league and let's put some holes in it.
| Attachments: |
Capture.JPG [ 57.78 KiB | Viewed 800 times ]
|
_________________
Jon Ellert
Motiv "Wannabee" Staff Member
|
|
| Top |
|
|
