| Author |
Message |
|
Jellert1
|
Post subject: Redrilling my Tx1, I finally have my info.  Posted: Sun May 13, 2012 10:56 pm |
|
Joined: Tue Jan 04, 2011 3:09 pm
Posts: 296
Location: Metro Detroit
|
|
Right handed
PAP = 6.25 over and 2.75 up
Speed = 17.6 @ Release
Rev Rate = 420
Axis Tilt = 2 degrees
My Tx1 was never my go to ball, but I really didn't do more than just stab 3 holes in it when I got it. On Friday I had a silver level coach help me get the above info. I would like to fill and redrill my Tx1 (3.5" pin) using the dual angle method. It will be my first time using this method. I'll be bowling on Brunswick lanes with a 42' THS which I think is actually the Kegel Stone Street pattern. I prefer ball motions that have a fairly late, not too agressive snap. Balls that make extreme snappy (skid / flip) motions have never worked well for me. Every ball I have drilled is a full roller lay out. I'm open to all sugestions, this should be a very educational experiment for me. Thank you in advance.
_________________
Jon Ellert
Motiv "Wannabee" Staff Member
|
|
| Top |
|
 |
|
JustinWi
|
Post subject: Re: Redrilling my Tx1, I finally have my info. Posted: Mon May 14, 2012 8:00 pm |
|
Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1688
Location: Rochester NY
|
|
60x25@5.25" no hole to start, you'll like the strong arc backend.
|
|
| Top |
|
|
|
Jellert1
|
Post subject: Re: Redrilling my Tx1, I finally have my info. Posted: Mon May 14, 2012 10:20 pm |
|
Joined: Tue Jan 04, 2011 3:09 pm
Posts: 296
Location: Metro Detroit
|
|
Thanks Justin, I'll drill it up and post the results.
_________________
Jon Ellert
Motiv "Wannabee" Staff Member
|
|
| Top |
|
|
