motivbowling.com
http://www.motivbowling.com/forum/

Help me layout a QZ1 purple
http://www.motivbowling.com/forum/viewtopic.php?f=8&t=260
Page 1 of 1

Author:  TooMuchHand [ Mon Dec 21, 2009 1:26 pm ]
Post subject:  Help me layout a QZ1 purple

This will probably be my next ball.

Here are my specs:
PAP - 4 7/8" left; 3/4" up
Rev - 380-400
Speed - 19-19.5 mph

What specs should I look for in the ball? I want something to make it through the feathers and make a strong move on the back end. I do not want to have swing out to the dry to make it hook. I leave too many 7's this way. Something that charges hard off the 2nd range finder would suit me best.

Thanks in advance!

Author:  Brian.Woodman [ Mon Dec 21, 2009 2:28 pm ]
Post subject:  Re: Help me layout a QZ1 purple

The one thing I have noticed is the QZ1's is they roll better with a little surface. I would recommend putting the surface at 2000 Scuff Polish, then clean it and hit it with a 500 abralon pad. After that I would do a longer pin from your PAP to reduce track flare and try to keep it above the fingers. That would still leave you enough backend to hopefully chop that 7 pin out but still utilize the ball with the surface, but that is for a house shot type of condition.

Author:  TooMuchHand [ Mon Dec 21, 2009 2:32 pm ]
Post subject:  Re: Help me layout a QZ1 purple

That sounds like a good approach. Most of my equipment has the pin 1/2" to 2" above my ring.

Author:  JustinWi [ Mon Dec 21, 2009 3:59 pm ]
Post subject:  Re: Help me layout a QZ1 purple

45x40@4" P2 or P3 hole.

1000 Abralon to start.

Author:  evil858 [ Tue Dec 29, 2009 1:25 am ]
Post subject:  Re: Help me layout a QZ1 purple

if you really want to tighten the flare on the ball put a flare decreasing hole on the left side of your v a l ive seen flare on other balls go from four inches down to two inches by doing this

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/