Ok... I'm an HVAC guy so I've got some crap lying around. I have a motor, which I think would be a decent, just-strong-enough motor for a ball spinner. Pretty sure it's 1/4 HP.
Is there a way to buy an attachment for the shaft, which is essentially a ball cup, that will stay on the shaft with a set screw? Or is there some other rigged up ideas out there for it? I'm just brain-storming what to do. Throw some ideas at me!
_________________ Jason "Jay Dub" Winchester Cincinnati, OH Silver Rx1 Sr2 Primal Impulse Bad weather ball Storm Ice Spareball
Check youtube for homemade bowling ball spinners. One guy used an old food prosesser. I use a vortex 1/2 HP persional ball spinner. Haven't had a problem ever with it. Keeps the ball steady and does a killer job without maxing out my credit card. Rather spend the 250 on a kick @$$ spinner then tinker with spare parts and spend 3 bills. Checkout http://www.buddiesproshop.com/products/ ... inners.htm
_________________ Motiv Staff
RX1s 60x6x70 QZ2 1 inch pin to pap Thrash 1 inch pin to pap QZ2 BACKDRAFT 60x5x65 TZ3 70x5.5x30 Primal Impulse 90x3.5x55 Primal Impulse 75x5.5x40 Sigma Tour 80x5.5x40 Raptor Attack 95x5.25x30 Raptor P7 45x4.5x30 P1
Users browsing this forum: No registered users and 3 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum