| Author |
Message |
|
gcruise815
|
Post subject: Drilling advice to get ball down lane  Posted: Sat Mar 02, 2013 10:48 am |
|
Joined: Wed Jul 06, 2011 11:06 pm
Posts: 12
Location: Neenah, WI
|
|
I need advice on drilling to get the ball through the mid lane with my tilt/rotation especially when the shot breaks down. Seems like eveything I have reads the mids early but does not rev up in the back end. I can get to the pocket with no problems but no carry, the ball does not roll out but my carry stinks and I have no room.... Any advice is appreciated.
_________________
Guy Cruise
Neenah, WI
RH / 325 revs
PAP - 4 3/4 X 3/4up
Rotation - 40 degrees
Tilt - 24 degrees
Speed @ sensor - 16 mph
Raptor - 55 x 5 x 35 P3
Sigma Tour - 50 x 3.75 x 45
|
|
| Top |
|
 |
|
JustinWi
|
Post subject: Re: Drilling advice to get ball down lane Posted: Wed Mar 06, 2013 1:15 am |
|
Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1690
Location: Rochester NY
|
|
High tilt and low rotation can be tough.
Try long Pin to PAP on Asymmetrical balls, short on symmetrical balls to manage tilt and ensure max carry.
|
|
| Top |
|
|
|
PurplehazeFFC
|
Post subject: Re: Drilling advice to get ball down lane Posted: Wed Mar 06, 2013 1:22 am |
|
Joined: Wed Mar 06, 2013 1:14 am
Posts: 6
|
|
How about a MOtion hole???
From what ive read it gives extra lenth & backend
that just may help..
Thou have a good read & ask question from ppl in the know
_________________
MOTIV 2Cruel
MOTIV Raptor P7
MOTIV Sigma Tour
MOTIV Venom Toxin
MOTIV 3 Ball Tote
MOTIV 2 Ball Tote
Dexter SST8 SE
MOTIVated in Australia
|
|
| Top |
|
|
