Author |
Message |
Moldyhoho
|
Post subject: Dual angle Posted: Tue Feb 25, 2014 11:57 pm |
|
Joined: Tue Feb 25, 2014 12:05 pm Posts: 2
|
If I wanted to know what angles were used to drill my ball how would I work backwards with the ball already punched. What lines need to be drawn and from where? Thanks
Eugene
|
|
Top |
|
 |
jt_shanks
|
Post subject: Re: Dual angle Posted: Thu Feb 27, 2014 12:57 pm |
|
Joined: Sat Jun 05, 2010 4:09 pm Posts: 60 Location: Fort Collins Colorado
|
pretty good vid: https://www.youtube.com/watch?v=Oq8SG1rqdCwedit: helps to know your PAP
_________________ Jim
Motiv Gear (14#): TZ3 55 x 4.75 x 30 Primal 60 x 4.5 x 30 Cruel 40 x 4 x 40 Sigma Hybrid 30 x 4.5 x 60 Sniper
RH Stroker PAP: 4.625 ^ 1.125 15-15.5 mph 260 RPM Axis Rot.: 55 - 60 Tilt: 44
|
|
Top |
|
 |
gwendel
|
Post subject: Re: Dual angle Posted: Tue May 20, 2014 11:37 pm |
|
Joined: Fri Feb 04, 2011 2:28 pm Posts: 11
|
I can do it, lets see if I can explain it. First you need to know your PAP. If you do, then.. Draw a line with quarter scale through center of grip bridge to thumb. Then find half way point of span. I.E. 4-1/2 total span mark 2-1/4 on mid line. Draw a 90 degree line from that point to the right (for a right hander) Use your PAP over measurement and mark it. Draw a 90 degree line from over mark to create VAL. mark your Up/Down PAP. Draw a line from pin to mass bias, or on a symmetric ball pin through CG 6-3/4 mark a virtual Mass Bias. Draw a line from PAP to Pin. This should give you all the marks and angles. Just measure them.
|
|
Top |
|
 |