| Author |
Message |
|
akf43
|
Post subject: new Raptor  Posted: Fri Aug 12, 2011 7:31 pm |
|
Joined: Tue Oct 26, 2010 6:34 pm
Posts: 12
|
|
I drilled up a Raptor last week and instead of it going long and hooking it just goes long. My stats are 17 mph low revs drilled 40x4x40. Any suggestions.
|
|
| Top |
|
 |
|
JustinWi
|
Post subject: Re: new Raptor Posted: Fri Aug 12, 2011 11:14 pm |
|
Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1688
Location: Rochester NY
|
|
Stats are RPM, Rev Rate, Tilt, rotation. If you twirl it, box finish may be inadequate. Try 1k Abalon.
|
|
| Top |
|
|
|
akf43
|
Post subject: Re: new Raptor Posted: Sat Aug 13, 2011 12:25 am |
|
Joined: Tue Oct 26, 2010 6:34 pm
Posts: 12
|
|
I don't twirling It. I don't know tilt or rotation but I prett much come up the back of the ball it has a lot of roll but not much hook
|
|
| Top |
|
|
|
FUPAsnack
|
Post subject: Re: new Raptor Posted: Sat Aug 13, 2011 2:15 am |
|
Joined: Mon Feb 14, 2011 12:50 pm
Posts: 1201
Location: San Antonio, TX
|
|
Kind of sounds like you might have to plug and drill again, but Justin can be the final judge on that issue.
|
|
| Top |
|
|
|
JustinWi
|
Post subject: Re: new Raptor Posted: Sat Aug 13, 2011 8:48 am |
|
Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1688
Location: Rochester NY
|
|
I'm sorry if I came across a little short in my first post, I was trying to work through a bunch of threads to catch up. I have a trade show today, I'll answer your question later tonight.
|
|
| Top |
|
|
|
akf43
|
Post subject: Re: new Raptor Posted: Tue Aug 23, 2011 1:15 pm |
|
Joined: Tue Oct 26, 2010 6:34 pm
Posts: 12
|
|
In my post i said my Raptor didnt hook. Well I want to correct that. I watched videos of my release and i was topping the ball. Im practicing keeping my hand behind the ball. I can tell you when i release it good the Raptor hooks plenty and hits very hard. I didnt want to bad mouth a ball when it was user error.
|
|
| Top |
|
|
