| Author |
Message |
|
badbeard
|
Post subject: can't get raptor core to rev up  Posted: Tue Sep 06, 2011 9:45 pm |
|
Joined: Sun Jul 10, 2011 5:12 pm
Posts: 112
|
|
so far i can not get the raptor core to rev up . my sig t does and also my primal but not the raptor. I have it all plugged up and ready for a new layout. any ideas my specs are below
_________________
speed dom 18 at pin deck
rev 180-210
tilt 13
ro 40-50
PAP 4 1/2 X 1 1/2 Up
sweet spot
45/3.25/30 asym
50/3.25/25 sym
Rap Attack 60/4/40
Sig tour 45/3.25/25 obf
Primal t4 55/ 4.75/45
Rap 55/3/25 + p3
Primal Im 45x 3.375 x 40 wi hole
Thrash 50x4.25x35
|
|
| Top |
|
 |
|
badbeard
|
Post subject: Re: can't get raptor core to rev up Posted: Wed Sep 07, 2011 9:08 am |
|
Joined: Sun Jul 10, 2011 5:12 pm
Posts: 112
|
|
thinking on drilling this ball 30x 3.25 x 30 what ball motion will this get me ?
_________________
speed dom 18 at pin deck
rev 180-210
tilt 13
ro 40-50
PAP 4 1/2 X 1 1/2 Up
sweet spot
45/3.25/30 asym
50/3.25/25 sym
Rap Attack 60/4/40
Sig tour 45/3.25/25 obf
Primal t4 55/ 4.75/45
Rap 55/3/25 + p3
Primal Im 45x 3.375 x 40 wi hole
Thrash 50x4.25x35
|
|
| Top |
|
|
|
Sikfish
|
Post subject: Re: can't get raptor core to rev up Posted: Wed Sep 07, 2011 1:33 pm |
|
Joined: Wed Aug 11, 2010 10:04 am
Posts: 102
Location: Coldwater, Michigan
|
|
...being speed dominant as you are I would close the drilling angle down as you have done and leave the polish off. I had a touch of trouble with mine at the box surface, but took it to 2000 and it's a beast, my second one is polished.
|
|
| Top |
|
|
|
Sikfish
|
Post subject: Re: can't get raptor core to rev up Posted: Thu Sep 08, 2011 1:30 pm |
|
Joined: Wed Aug 11, 2010 10:04 am
Posts: 102
Location: Coldwater, Michigan
|
|
Badbeard...this would be the ball to try the 60 x 4" x 50 on, if it's plugged already.....
see your other post for my thoughts.....
|
|
| Top |
|
|
