MOTIV

Username: Log me on automatically each visit
Password:
It is currently Wed Apr 16, 2014 9:37 pm


Post a new topicPost a reply Page 1 of 1   [ 6 posts ]
Author Message
 Post subject: SX-1 layout
PostPosted: Mon Sep 20, 2010 4:28 pm 

Joined: Wed Aug 18, 2010 7:45 pm
Posts: 98
Location: Boulder,Co
I picked up an SX-1 to go between my purple QZ-1 and my Reacon.

curious on a drilling for it.
High rev med to slower speed.
Want it go get some length


Top
 Profile  
 
 Post subject: Re: SX-1 layout
PostPosted: Mon Sep 20, 2010 10:59 pm 

Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1698
Location: Rochester NY
The biggest thing to worry about will be the surface. 4k and polish if you want it go go long.

Take a second look at my recon vid, you can clearly see the difference between the SX1 and RX1 with identical drill patterns.

What layouts do you have on the other two balls?


Top
 Profile  
 
 Post subject: Re: SX-1 layout
PostPosted: Tue Sep 21, 2010 5:35 pm 

Joined: Wed Aug 18, 2010 7:45 pm
Posts: 98
Location: Boulder,Co
I went with High track length drilling on purple per drill sheet

and on the Reacon pin above ring small weight hole


Top
 Profile  
 
 Post subject: Re: SX-1 layout
PostPosted: Tue Sep 21, 2010 7:48 pm 

Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1698
Location: Rochester NY
Are you looking for a sharper or smoother breakpoint?


Top
 Profile  
 
 Post subject: Re: SX-1 layout
PostPosted: Tue Sep 21, 2010 8:29 pm 

Joined: Wed Aug 18, 2010 7:45 pm
Posts: 98
Location: Boulder,Co
I like the ball smooth.
The purple drilled on your suggestions as well as the Reacon are that way nice and smooth.

with the higher revs the ball being flippy for me, makes it difficult to be consistent


Top
 Profile  
 
 Post subject: Re: SX-1 layout
PostPosted: Tue Sep 21, 2010 11:22 pm 

Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1698
Location: Rochester NY
Before drilling, hit it with 4k Abralon, then Polish.

Do a 65x70@5". You most likely will not need one, but if you need it a bit weaker place a P1 hole. Keep an eye on the statics before you place the hole.

This layout is a bit weaker than the second SX1 featured in the Recon vid. The surface is at 1k Abralon in the video, with 4k and polish you should see a weaker reaction. Sliding the SX1 between the RX1 and QZ1 can be tough sometimes, it likes to hook.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 6 posts ]


Who is online

Users browsing this forum: Yahoo [Bot] and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

MOTIV