whats up guys... just punched up a 2cruel yesterday and rolled the best i have all season... third game i fell off but first 2 games were good for me... shot 212 248 166 ... now i drilled the ball with a layout i been wanting to try i went 55x4x20 and my driller placed the 2 1/4 deep 15/16 dia. weight hole 4" right on my midline

my pap is 5 7/8> 3/4^
speed 17mph
revs 450ish
45*rotation
12*tilt

ball stats
15lb 2oz
3.2oz top
3.5"pin cg 3/8 left of line through pin to mb
left at box finish

now the ball with this layout i thought would be long and flippy and its long but not flippy but the bowtie is id say at the 8pm mark of my thumb hole and seems to have 2-3 oil flare lines over the thumb hole...now can i plug the weight hole and move it somewhere else to move the bowtie and stop the flaring over the thumb hole?

anyone??

Question as to the placement of the wt. hole. Did you think that it would help it be "flippy"? Try plugging the wt. hole & placing it at P3. If it reads alittle early after this then I recommend hitting it w/3000 or 4000 lightly to delay the reaction. Hope this helps & good luck.

no i actually thought the layout i put on it would make it long and snappy , and the weight hole was just put on the midline to make the ball legal...and the spot its in i didnt think would alter the reaction...