| Author |
Message |
|
Purplehaze
|
Post subject: Drilling a Primal Scream Posted: Sun Mar 03, 2013 4:03 am |
|
Joined: Sat Jan 07, 2012 6:24 am Posts: 38
|
|
A layout for a Primal Scream.. That is 15lb 4oz. 3' pin, 3oz top weight..
Im having very good success with a Sigma Tour that is drilled 55 x 5 x 40.. Rolls beautifully
Looking at a stronger reaction for a heavier volume of oil with the Scream
Bowler Information: PAP = 5 over - 1/2 up Ball Speed = 16mph Rev Rate = 270 Tilt = 12 * Rotation = 50 *
Ball Information: Make and Model of ball(s) = Motiv Primal Scream Weight = 15lb 4oz Top Weight = 3oz Pin = 3' Desired reaction shape = I tend to play around the 10-15 board. So to go through the oil with a sharp but controlled breakpoint Will try the ball a OOB. Then tweak surface if needed
Thanks
_________________ 2Cruel - 2000 Polish Raptor P7 - 2000 Sigma Tour - 2000
MOTIVated in Australia
|
|
| Top |
|
 |
|
JustinWi
|
Post subject: Re: Drilling a Primal Scream Posted: Wed Mar 06, 2013 1:16 am |
|
Joined: Thu Aug 27, 2009 10:43 pm Posts: 1688 Location: Rochester NY
|
|
| Top |
|
 |