| Author |
Message |
|
pckmn53
|
Post subject: New Ball and Layout  Posted: Thu Dec 05, 2013 1:38 pm |
|
Joined: Wed Dec 04, 2013 2:50 pm
Posts: 4
|
|
Hi,
I just bought a Motiv Sigma Hybrid as I am going from 16lbs to a 15lbs. I only bowl one night a week on wood lanes with med heavy/heavy oil to about 42'. I am looking for an arcing reaction rather than a skid/snap. My current ball, an Ebonite Vortex v2, was drilled +10 yrs ago. The pin to PAP on that ball is 3 3/8". The rest of my specs are listed below. Thank you for your time and help and look forward to your recommendations.
John
Bowler Information:
PAP 6" over 1/2" up
Ball Speed 16.5-17.5 on the monitor
Rev Rate 320
Tilt 8*
Rotation 35*
|
|
| Top |
|
 |
|
JustinWi
|
Post subject: Re: New Ball and Layout Posted: Wed Jan 29, 2014 4:37 am |
|
Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1698
Location: Rochester NY
|
|
70x55@5", no hole to start.
|
|
| Top |
|
|
|
pckmn53
|
Post subject: Re: New Ball and Layout Posted: Wed Jan 29, 2014 2:49 pm |
|
Joined: Wed Dec 04, 2013 2:50 pm
Posts: 4
|
|
| Top |
|
|
|
pckmn53
|
Post subject: Re: New Ball and Layout Posted: Thu Jan 30, 2014 11:29 am |
|
Joined: Wed Dec 04, 2013 2:50 pm
Posts: 4
|
|
Justin,
Would this layout be my benchmark, midlane or control layout?
John
|
|
| Top |
|
|
|
JustinWi
|
Post subject: Re: New Ball and Layout Posted: Mon Feb 03, 2014 4:20 pm |
|
Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1698
Location: Rochester NY
|
|
With the shape of the hybrid most likely your midlane or control ball.
|
|
| Top |
|
|
|
pckmn53
|
Post subject: Re: New Ball and Layout Posted: Fri Feb 21, 2014 12:17 pm |
|
Joined: Wed Dec 04, 2013 2:50 pm
Posts: 4
|
|
Justin,
If a hole is needed where/how should it be drilled?
Thanks,
John
|
|
| Top |
|
|
|
JustinWi
|
Post subject: Re: New Ball and Layout Posted: Mon Feb 24, 2014 11:51 am |
|
Joined: Thu Aug 27, 2009 10:43 pm
Posts: 1698
Location: Rochester NY
|
|
That entirely depends on what adjustment to the reaction you are seeking.
|
|
| Top |
|
|
