Sigma Hybrid #1 - 60* X 5" X 35, P3


Box with my hand and up the back of the ball roll was too early for me, it's currently at 2000. Love, love, love the reaction! The pattern I used is my "benchmark" type of ball reaction that gives me length but also that shorter VAL angle that gives me the angle and response to friction I like to have generally on heavier volumes. Overall reaction is very smooth through the heads, almost like a Sigma Tour, but earlier in it's read and overall movement compared to the ST. I cannot wait to put this ball on Scorpion or anything with heavier volumes at a lower surface to see it's true potential.

That being said, I put holes in a second because it's just a HUMDINGER BABY!!(in a Dick Vitale voice)
Sigma Hybrid #2 - 70* X 6" X 45, hole between P3/P4(3/4 of total PAP to MB distance, ended up being right @ 4")

Took it up from box with 1500,2000,3000,4000. Gave me that "polished" look I was wanting to get out of it. Added 10 degrees on pin to PAP angle, 1" further on pin to PAP length, and added 10 degrees on VAL slightly lessening response and grab on friction. Overall, it's about 4 feet longer(with surface adjustments included) and about 4 or 5 boards overall less on overall performance. Definitely am looking to put this on some shorter shots to get a grasp of peak performance. Even though layouts are not SIGNIFICANTLY different, overall shapes on the lane are something that will give me a 1-2 punch for most of the harder stuff.

Overall - great release for Motiv. Can't wait to put them out on the regional stuff that's upcoming here in the Midwest!!