motivbowling.com
http://www.motivbowling.com/forum/

small problem
http://www.motivbowling.com/forum/viewtopic.php?f=8&t=1793
Page 1 of 1

Author:  Randy T [ Fri Oct 08, 2010 1:48 pm ]
Post subject:  small problem

Picked up RTX-1 as my 1st Motiv ball

love it and since have purchased an SX-1 and a QZ-1 and those are great also.

I put a pin above drilling on the Reacon and it is still a little to strong and is actually more than my SX-1.

The SX-1 is still a tad strong for this house so I am going to purchase another Reacon and put a weaker drilling on it and sell my other one

Should I drill the new Reacon up the same as my SX and QZ?

SX and QZ are drilled with the length layout high track drilling?

Author:  JustinWi [ Sat Oct 09, 2010 2:36 pm ]
Post subject:  Re: small problem

If you drill the RX1 and SX1 the same, they will react similarly but the recon will be at least a few boards weaker depending on your speed and revs.

My RX1 video compares them heads up in anticipation of questions like these.

Author:  Randy T [ Sat Oct 09, 2010 3:24 pm ]
Post subject:  Re: small problem

Thats what I figured but wanted to be sure
Thanks as always

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/